
SummitPx1 Application Switch Front View
Extreme Networks Consolidated Hardware Guide 103
NOTE
For more information about configuring and using the Summit24e3 switch, see the Summit24e3
Installation and User Guide.
SummitPx1 Application Switch Front View
The SummitPx1 application switch is 1U in height and has the following four ports:
• Network Interface port is a Gigabit Interface Connector (GBIC) with an SC connector used to connect
the application switch to your local network.
• 1000BASE-Tx Ethernet Management port with an RJ-45 connector is a 10/100 Mbps Ethernet
connection used for out-of-band management.
• Serial Management ports have two serial RJ-45 connectors. Use the console port to connect a
terminal for local out-of-band-management. Use the modem port for remote out-of-band
management.
Figure 42 shows the front view of the SummitPx1 application switch.
Figure 42: Front view of the SummitPx1 application switch
10/100 Mbps Port Status LEDs
Color Indicates
Green
Green blinking
Off
Link is present; port is enabled.
Link is present; there is activity.
Link is not present or the port is disabled.
Mini-GBIC Port Status LEDs
Color Indicates
Amber
Amber blinking
Frames are being transmitted and received on this port.
A non-supported GBIC is installed on this port.
Green
Green blinking
Off
Link is present; port is enabled for full-duplex operation.
Link is present; port is disabled.
Link is not present.
Table 31: Summit24e3 switch LED activity (continued)
SPx1_front
Unit status
LEDs
Network Interface
port
Ethernet
Management
LEDs and port
Serial
Management
ports
Comentários a estes Manuais