Extreme Networks WM-4T1i Especificações descarregar pdf (Página 248)

248 Extreme Networks Consolidated Hardware Guide

BlackDiamond 6800 Series I/O Modules

Table 71 describes the cable specifications for the RJ-21 connector. Appropriate cables are available from

your local supplier.

To access the ports, use a 180-degree male RJ-21 connector with a shielded PVC trunk cable and secure

to a maximum of 4 in-lbs of torque. You can access the ports in one of the following ways:

• Through a patch panel by terminating the cable and shield with an RJ-21 connector.

• Directly by using a cable that is terminated with 12 RJ-45 connectors.

The RJ-21 connector is shown in Figure 125.

Figure 125: RJ-21 connector

The default configuration of the F96Ti module is as follows. All ports:

• Are added to the default VLAN as untagged.

• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).

• Operate in auto-negotiation mode.

LEDs

The F96Ti module has a module status LED.

For information about the module status LED and its activity on the F96Ti module, see “I/O Module

LEDs” on page 271.

RxD (-)

TxD (-)

RxD (+)

TxD (+)

Table 71: F96Ti cable specifications

Connectors Cable Min Length Max Length Max Torque

Lucent 525 Telco 50-pin RJ-21 Shielded trunk cable with 12

CAT5 twisted pairs

1 m 100 m 4 in-lbs

Table 70: Output signals for the RJ-21 connector (continued)

RJ-21 Pin

Numbers

Output Signal

RJ-21 Pin

Numbers

Output Signal

XM_046

Screws secure

connector to port

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 335 336

Sem comentários

Extreme Networks WM-4T1i Especificações Página 248