Extreme Networks WM-4T1i Especificações descarregar pdf (Página 170)

170 Extreme Networks Consolidated Hardware Guide

Alpine 3800 Series I/O Modules

Software Requirements

The FM-24Ti module requires that you load ExtremeWare software version 6.1.7 or later and BootROM

6.5 or later on your switch.

FM-24SFi Module

Figure 81 shows the FM-24SFi module.

Figure 81: FM-24SFi module

The FM-24SFi module has 24 100 Mbps Ethernet ports, using standard MT-RJ connectors. The FM-24SFi

module supports 100BASE-FX in single mode only.

The default configuration of the FM-24SFi module is as follows. All ports:

• Are added to the default VLAN as untagged.

• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).

• Operate in 100 Mbps, single mode. Half-duplex mode is not supported.

The total optical system budget for the FM-24SFi module is 11 dB. Measure cable plant losses with a

1310 nm light source to verify that your cable plant losses are within the optical budget. Table 48

describes the optical specifications for the FM-24SFi module

LEDs

The FM-24SFi module has the following LEDs:

• Module status

• Port status

Table 48: FM-24SFi optical interface specifications

Parameter Minimum Typical Maximum

Transceiver

Optical output power -20 dBm -14 dBm

Center wavelength 1510 nm

Receiver

Optical input power sensitivity -31 dBm

Optical input power maximum -8 dBm

Operating wavelength 1510 nm

General

Total system budget 11 dBm

FM-24SFi

Module status LED

242322212019181716151413121110987654321

100 Mbps ports

with status LEDs

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 335 336

Sem comentários

Extreme Networks WM-4T1i Especificações Página 170