Extreme Networks ExtremeWare XOS Command Especificações descarregar pdf (Página 273)

100

101

enable log target

ExtremeWare XOS 10.1 Command Reference Guide 273

enable log target

enable log target [console | memory-buffer | nvram | session | syslog [all

| ipaddress] [local0 ... local7]]]

Description

Starts sending log messages to the specified target.

Syntax Description

Default

Enabled, for memory buffer and NVRAM; all other targets are disabled by default.

Usage Guidelines

This command starts sending messages to the specified target. By default, the memory-buffer and the

NVRAM targets are enabled. Other targets must be enabled before messages are sent to those targets.

Configuration changes to the session target are in effect only for the duration of the console display or

telnet session, and are not saved in FLASH. Others are saved in FLASH.

Example

The following command enables log messages on the current session:

enable log target session

console Specifies the console display.

memory-buffer Specifies the switch memory buffer.

nvram Specifies the switch NVRAM.

session Specifies the current session (including console display).

syslog Specifies a syslog target.

all Specifies all of the remote syslog servers.

ipaddress Specifies the syslog IP address.

local0 ... local7 Specifies the local syslog facility.

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 757 758

Comentários a estes Manuais

Sem comentários

Extreme Networks ExtremeWare XOS Command Especificações Página 273

Comentários a estes Manuais