Extreme Networks Summit WM Series Guia do Utilizador descarregar pdf (Página 127)

The Analysis Engine

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

127

● known Altitude AP with an unknown SSID (major alarm)

● in ad-hoc mode (major alarm)

NOTE

In the current release, there is no capability to initiate a DoS attack on the detected rogue access point.

Containment of a detected rogue will require an inspection of the geographical location of its Scan Group area

(where its RF activity has been found).

View the Summit Spy scan results and build list of friendly APs

1 Click on the Summit Spy tab in any screen Then click on the Rogue Detection tab. The Rogue

Detection screen appears displaying all access points and Altitude APs that were found in the scan

but are not in the database of known devices (as defined above).

2 To modify the rate that this information is refreshed, key in a time in seconds and click on the Apply

button.

3 To remove an access point from this list, click on the Delete button.

4 To add an access point or Altitude AP to the Friendly APs list, click on the Add to Friendly List

button. The access point item will be removed from this list and will appear in the Friendly APs list.

A third-party access point will always appear first as a Rogue AP. Add it to the Friendly AP list as

noted above.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 227 228

Sem comentários

Extreme Networks Summit WM Series Guia do Utilizador Página 127