Extreme Networks WM-4T1i Especificações descarregar pdf (Página 120)

5-4 Extreme Networks Consolidated Hardware Guide

Summit Switch Installation

9 If you are installing a Summit7i switch, remove the helper bracket after the chassis is

secured.

10 Connect the Summit switch to a redundant power supply (if applicable).

11 To turn on power to the system, connect the AC power cable(s) to the switch and

then to the wall outlet(s). For the Summit4, Summit24, and Summit48 switches, turn

the on/off switch to the on position.

Note: The Summit1i, Summit5i, Summit7i, Summit48i, Summit48si, Summit24e3,

Summit24e2, and SummitPx1 switches do not have on/off switches.

Placing the Switch on a Table or Shelf

The Summit switch comes with four self-adhesive rubber pads. Apply the pads to the

underside of the switch by sticking a pad in the marked area at each corner of the

switch.

You can place up to four Summit switches on top of one another.

Apply the pads to the underside of each switch, and place a pad at each corner of the

switch. Place the switches on top of one another, ensuring that the corners align.

Removing and Installing Summit48si Power

Supplies

Note: Summit48si power supplies must be serviced by trained service personnel.

Note: If you need to power down the switch, remove all of the power cords from

the installed power supplies.

To remove a Summit48si power supply:

1 Remove the power cord.

Caution: Shock hazard.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 305 306

Sem comentários

Extreme Networks WM-4T1i Especificações Página 120