Extreme Networks WM-4T1i Especificações descarregar pdf (Página 282)

A-2 Extreme Networks Consolidated Hardware Guide

Safety Information

• Disconnect power before removing the back panel of an Alpine switch or

BlackDiamond switch.

• The unit must be grounded. Do not connect the power supply unit to an AC outlet

without a ground connection.

• The unit must be connected to a grounded outlet to comply with European safety

standards.

• The socket outlet must be near the unit and easily accessible. You can only remove

power from the unit by disconnecting the power cord from the outlet.

• This unit operates under Safety Extra Low Voltage (SELV) conditions according to

the IEC 950 standard. The conditions are only maintained if the equipment to which

it is connected also operates under SELV conditions.

• The appliance coupler (the connector to the unit and not the wall plug) must have a

configuration for mating with an EN60320/IEC320 appliance inlet.

• France and Peru only

This unit cannot be powered from IT† supplies. If your supplies are of IT type, this

unit must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with

the secondary connection point labeled Neutral and connected directly to ground.

Power Cord

The power cord must be approved for the country where it is used:

• USA and Canada

— The cord set must be UL-listed and CSA-certified.

— The minimum specification for the flexible cord is No. 18 AWG (1.5 mm

), Type

SVT or SJT, 3-conductor.

— The cord set must have a rated current capacity of at least the amount rated for

each specific product.

— The AC attachment plug must be an Earth-grounding type with a NEMA 5-15P

(10 A, 125 V) configuration.

• Denmark

— The supply plug must comply with section 107-2-D1, standard DK2-1a or

DK2-5a.

• Switzerland

— The supply plug must comply with SEV/ASE 1011.

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 305 306

Sem comentários

Extreme Networks WM-4T1i Especificações Página 282