Extreme Networks WM-4T1i Especificações descarregar pdf (Página 236)

15-8 Extreme Networks Consolidated Hardware Guide

BlackDiamond 6800 Series Management Switch Module

As the MSM64i begins to seat in the chassis, the ejector/injector handles begin to

close.

4 To close the ejector/injector handles, use both hands simultaneously to push the

handles toward the center of the module.

5 To secure the module, tighten the two screws with a #1 Phillips screwdriver.

Note: Tighten the screws before you insert additional modules. Otherwise, you

might unseat modules that you have not secured.

6 Repeat this procedure for each additional MSM64i module, if applicable.

After a slave MSM64i is installed, use the

synchronize command to replicate all

saved images and configurations from the master MSM64i to the slave MSM64i.

Caution: Depending on the size and complexity of your network, you should

install and configure a slave MSM64i module when there will be minimal network

disruption. You may need to reboot your switch after you use the

synchronize

command.

7 Leave the ESD strap permanently connected to the chassis, so that it is always

available when you need to handle ESD-sensitive components.

Caution: You can install the MSM64i only in the designated (orange) slots. The

MSM64i does not fit in any other chassis slots.

Adding SODIMMs to the MSM64i Module

The MSM64i supports only SODIMMs from Extreme Networks.

To add a SODIMM to the MSM64i:

1 Attach an ESD strap to your wrist and connect the metal end to the ground

receptacle that is located on the top-left corner of the switch front panel.

2 Locate the SODIMM sockets on the MSM64i.

3 Position the SODIMM in the socket by ensuring that the gold fingers of the

SODIMM slip into the connector and the keying notches align.

4 Secure the SODIMM by pressing down firmly until it is locked into the socket and

the ejector locks rotate into position, as shown in Figure 15-5.

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 305 306

Sem comentários

Extreme Networks WM-4T1i Especificações Página 236