Extreme Networks WM-4T1i Especificações descarregar pdf (Página 143)

Extreme Networks Consolidated Hardware Guide 7-11

Installing the Chassis

Use the show switch command to display the current switch information, including

the mode of switch operation.

Use the

show version command to display hardware and software versions currently

running on the switch as well as the riser card serial number (the riser card supports

connection to the I/O slots). Information about the power supplies is not displayed.

Installing the Chassis

The Alpine 3800 series chassis fits in standard 19-inch (48.26-cm) racks. The Alpine 3808

measures 12 U in height, the Alpine 3804 measures 6 U in height, and the Alpine 3802

measures 4 U in height.

The Alpine 3808 and Alpine 3804 chassis is shipped empty. For your safety, due to the

increased weight of the chassis after components are installed and to prevent damage to

the equipment, we strongly recommended that you install the power supply and

modules after you mount the empty chassis in a rack.

The Alpine 3802 chassis is shipped with a preinstalled power supply and fan tray. For

your safety, due to the increased weight of the chassis after components are installed

and to prevent damage to the equipment, we strongly recommend that you install the

I/O modules after you mount the chassis in a rack.

Note: Mount the chassis in a rack before installing any switch components.

Rack Installation

To mount the Alpine 3800 series chassis in a rack:

1 Mount the helper bracket in the lowest available position in the rack using four

appropriate screws, as shown in Figure 7-7.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 305 306

Sem comentários

Extreme Networks WM-4T1i Especificações Página 143