Extreme Networks WM-4T1i Especificações descarregar pdf (Página 164)

9-4 Extreme Networks Consolidated Hardware Guide

Alpine 3800 Series Switch Management Module

Note: Use the metal panel, not the PCB, to guide the SMMi.

As the SMMi begins to seat in the chassis, the ejector/injector handles begin to close.

4 Use one hand to hold the module in place and use the other hand to close the

ejector/injector handles by pushing them toward the center of the module.

5 Tighten the module screws using a #2 Phillips screwdriver.

Note: Tighten the screws of this module before you insert additional modules.

Otherwise, you might unseat modules that you have not secured.

6 Leave the ESD strap permanently connected to the chassis, so that it is always

available when you need to handle ESD-sensitive components.

Adding SODIMMs to the SMMi Module

The SMMi supports only SODIMMs from Extreme Networks.

To add a SODIMM to the SMMi:

1 Attach an ESD strap to your wrist and connect the metal end to the ground

receptacle that is located on the top-right corner of the switch front panel.

2 Locate the SODIMM sockets on the SMMi.

3 Position the SODIMM in the socket by ensuring that the gold fingers of the

SODIMM slip into the connector and the keying notches align.

4 Secure the SODIMM by pressing down firmly until it is locked into the socket and

the ejector locks rotate into position, as shown in Figure 9-4.

Figure 9-4: Adding a SODIMM

38_SODM

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 305 306

Sem comentários

Extreme Networks WM-4T1i Especificações Página 164